Glue Stained Sandstone Hallway Restoration in Carbrooke, Norfolk

This was perhaps the most challenging restoration we have been presented with to date.
The work involved removing carpet and underlay from a long Yorkstone tiled hallway at a beautiful old Grange in Carbrooke on the outskirts of Watton and restoring the flagstones to their original glory. These pavers are a type of Sandstone, a carboniferous sedimentary rock consisting of quartz, mica, feldspar, clay and iron oxides quarried in Yorkshire and having a rich sandy colour with a slightly sparkling surface.

On lifting the carpet, we found, to our dismay, that the rubber-backed underlay had been firmly stuck down to the surface of the stone with what appeared to be a thick layer of yellowing impact adhesive which covered the entire area right up to the thresholds and skirting boards.

Yorkstone Hallway Restoration Carbrooke Carpet Removed Revealing Underlay Yorkstone Hallway Restoration Carbrooke Glue Covering Entire Floor Surface

Stripping Carpet Adhesive off a Sandstone tiled floor

Our first task was to remove as much of the underlay by hand using sharp-bladed scrapers and a heck of a lot of elbow grease. Having done this, the next step was to cover the remaining adhesive layer with a specialist water-based stripper which was applied by brush and allowed to react for an hour. The result was an incredibly sticky substance with the consistency of chewing gum which we had to painstakingly remove inch by inch with paint scrapers. This process had to be repeated twice as even the specialist stripper couldn’t cope with the sheer volume of goo in a single application. The floor was then left overnight to dry out and settle down.

Yorkstone Hallway Restoration Carbrooke Applying Stripper Yorkstone Hallway Restoration Carbrooke Stone Surface After Stripping

The following day, we deep-cleaned the whole area using very strong mix of Tile Doctor Pro Clean and Remove & Go, scrubbed in with a rotary machine fitted with a black stripping pad. Four pads were used up in this process as they quickly became clogged with the thick slurry which was then power rinsed and vacuumed away from the floor. Any remaining patches of the glue were further softened using Tile Doctor Nanotech HBU Remover and carefully picked off by hand with the bladed scrapers.

Yorkstone Hallway Restoration Carbrooke Deep Cleaning Yorkstone Hallway Restoration Carbrooke Stone Surface After Deep Cleaning

Finally, the slabs were finished using a brush fitted to the rotary machine with 320 grit honing powder to achieve a smooth, silky and very clean surface before being power rinsed with plenty of clean water. Again, the floor was left to dry thoroughly overnight with the assistance of our large capacity dehumidifier and thermostatic hot air blower.

Sealing a Sandstone tiled floor

Returning the following day, we found that the dehumidifier and heater had done their job and the sandstone was ready for sealing, the moisture content having been brought down to an average of 10% overall as shown by our damp meter testing.

The client had requested a light shine on the floor so that it would be easy to maintain on a daily basis. We chose, therefore, to use Tile Doctor Seal & Go, a combination sealer with a mid-sheen topical finish, which we applied using paint pads and microfibre cloths in five thin coats, resulting in an excellent fluid resistant seal with a lustrous shine.

Yorkstone Hallway Restoration Carbrooke Applying Sealer To Edges Yorkstone Hallway Restoration Carbrooke Finished Floor

This was a tough job but a highly satisfying result, further emphasised when the client’s antique furnishings were placed in situ.
 
 
Source: Sandstone Tile Cleaning and Renovation Service in Norfolk

Resolving Yorkstone Installation by Cowboy Builders Near Leeds

In an interesting turn of events, I was recently contacted again by a homeowner from Guiseley, near Leeds, with whom I had been in touch with two years prior. At that time, I had quoted for cleaning and maintenance work to be carried out on a Yorkshire Stone, or ‘Yorkstone’ tiled floor, but the customer had opted to go with a different company. Yorkstone is a variety of Sandstone that it unique to the quarries of Yorkshire.

When the customer called me again, she explained that the previous work – most likely carried out by inexperienced cowboy builders – had been disastrous. The stone evidently had not bene properly cleaned and very little sealer had been used to protect it against wear and tear. The result was a very dirty and dusty floor – and the only solution was to start the restoration process over again, this time with the help of a true professional!

Here’s a photo of what the floor looked like before the restoration:

Yorkshire Stone Floor Guiseley Leeds Before Cleaning

Cleaning Dull and Dirty Yorkstone Tiles

Since the floor had not been cleaned properly to begin with, there were several unsightly paint stains on the stone in addition to general dirt and stains. To remove these, I applied Tile Doctor Pro Clean, which is a reliable alkaline cleaner, liberally across the floor and left it dwell for a short period. I then used a wire brush to scrub away the muck.

The customer had asked the builder to grout the tiles to reduce the likelihood of trapped dirt and make the floor feel complete. For whatever reason, builder either wouldn’t or couldn’t oblige, so I grouted the whole floor as well, much to the customer’s delight.

Sealing Yorkstone Tiles

Once the floor was fresh and clean, it was left to dry completely so it could subsequently be sealed.

My choice of sealer was Tile Doctor Seal and Go, a topical sealer which provides both a stain resistant surface seal and a durable and aesthetically-pleasing low-sheen finish to really enhance the character of the stone. Four coats of sealer were used in total to ensure maximum protection.

Here’s what the floor looked like after the restoration:

Yorkshire Stone Floor Guiseley Leeds After Cleaning

After cowboy builders had botched the job, the customer was exceptionally happy that the situation had finally been put right. The floor is now in top shape and will be protected against wear and tear for a long time to come.
 
 
Source: Yorkstone Tile Cleaning and Maintenance Service in North West Yorkshire

Sealing Newly Installed Sandstone Tiles in Yorkshire

Yorkstone is a variety of Sandstone unique to Yorkshire, and is known for its hard wearing and durable qualities. It was first manufactured during medieval times, but is still used for a range of building and construction purposes including, of course, tiled floors in houses. Yorkstone comes in a variety of natural colours, depending on the mineral makeup of the stone, and means that the tiled floors often have a unique look to them.

Yorkshire Stone Floor Before Cleaning and Sealing Driffield

This customer, living in the small Yorkshire town of Driffield is the lucky owner of a fantastic new Yorkstone tiled living room floor. Unfortunately, the floor had been installed by an independent builder, as opposed to a professional tiling company, and had been left with no sealer to ensure it would stay looking great for a long time to come. Over time, the lack of a sealer has allowed the dirt to become ingrained in the stone, making it increasingly difficult for the customer to keep the tiles clean. I was called in to bring completion to what was an unfinished job!

Yorkshire Stone Floor Before Cleaning and Sealing Driffield

Cleaning a Yorkstone Tiled Living Room Floor

As you can see from the photographs, the entire floor was quite dusty and dull looking following the recent installation. To get the tiles clean, I mixed a strong 60-40 mix of Tile Doctor Pro Clean and clean water. Pro Clean is a reliable alkaline cleaner suitable for use on most natural stone floors, including Sandstone, Quarry, and Slate.

The cleaning solution was applied to the floor and left to dwell for 20 minutes, allowing it time to penetrate the stone. Then, using my 17” rotary machine fitted with a black scrubbing pad, I proceeded to deep clean the tiles, leaving them looking immediately cleaner and more vibrant. Any resulting cleaning residue was promptly soaked up using a wet vacuum.

Yorkshire Stone Floor After Deep Cleaning Driffield

The process was repeated in the more stubborn areas, and I gave the floor a final rinse with water and left it to dry. Typically, we would leave a 12 to 24 hour drying period, depending on whether there is a damp proof membrane installed. However, this floor had underfloor heating and so dried really quickly, allowing me to seal it on the same day.

Sealing a Yorkstone Tiled Living Room Floor

The customer wished to have a matt, natural finish for the Yorkstone tiled living room, so I applied two coats of Tile Doctor Colour Grow, our impregnating sealer which offers a natural, no-sheen look for textured floors, while providing durable protection against ingrained dirt and stains.

Yorkshire Stone Floor After Cleaning and Sealing Driffield

As the name of the product suggests, Colour Grow contains colour intensifying properties which really helped to accentuate the rich variety of colours in the customer’s Yorkstone tiles. The results were fantastic and you can see from the water test we performed after the sealer dried how water now bubbles up on the surface of the stone.

Yorkshire Stone Floor Cleaned and Sealed Water Test Driffield

 
 
Source: Sandstone Tile and Grout Cleaning and Sealing Service in Yorkshire